Editing Blog/2025-12-12/Spaghettification (section)

== Broken Nozzle ==

But then when I looked closer at the whole thing, the nozzle itself was off the rest of the hotend assembly, and PETG had blown out the back. All right, c'est la vie. So I heated the hotend, scraped off the plastic, and scooped out some from the nozzle and figured I could just print something to purge the nozzle. Sadly, this was not to be. I couldn't quite get the nozzle back on and any further attempt to print would just pop it right off. I tried a few times, and pointlessly even tried some PLA. It's obvious if the PETG won't get out that the PLA won't either so this was an exercise in futility.
[[File:Bambu P1S - Replacement 0.4mm nozzle.webp|thumb|left|The replacement nozzle, with the old broken one in the back]]