Editing Blog/2026-01-11/Modeling With Claude (section)

=== CA Glue ===

Cyanoacrylate glue is pretty good for stick the magnets in their holes, but it works better on the side surfaces than on the poles. My first few tries, I had it on the far pole, but it would detach every time.

While I was doing the polarity trick previously mentioned, the extra magnet I was just about to stick in a hole would be sticking to a magnet that is already in a hole and it's the only one sticking out of that surface, so I could easily paint the outside with the superglue tip and shove it in the opposing hole.

Worked like a charm!

CA Glue is apparently not the best choice for PETG, but there was no way I was breaking out epoxy for this.

Unfortunately, while doing this, I managed to stick 5 of the magnets together. They were both magnetically and adhesively connected and there was no prying them apart.